How to install LED strips in different scenes

Led light strips can be applied to different scenarios, whether indoor or outdoor, many factors should be considered when installing. For example, when installing outdoors, it is necessary to consider whether the led light strip is waterproof.


1. Power connection method: The general voltage of the LED light strip is DC 12V, so it needs to use a switching power supply. The size of the power supply is determined according to the power and connection length of the LED light strip.


2. Controller connection mode: LED marquee strips and RGB full-color light strips need to use a controller to achieve a changing effect, and the control distance of each controller is different. Generally speaking, the control distance of a simple controller is 10 to 15 meters, the control distance of the remote controller is 15 to 20 meters, and the longest distance can be controlled up to 30 meters. if


3. Outdoor installation: Because outdoor installation is subject to wind and rain, it cannot be fixed with 3M glue. Therefore, outdoor installation usually adopts the card slot fixing method, where cutting and connection are required. The method is the same as indoor installation, but additional equipment is required. Waterproof glue to consolidate the waterproof effect of the connection point.


4. Indoor installation: LED light strips are relatively simple for indoor installation because they don't have to withstand wind and rain. When installing, you can directly tear off the sticker on the surface of the 3M double-sided adhesive on the back of the light bar, and then fix the light bar to the place where it needs to be installed and press it flat. If you encounter a corner or the light bar is too long or too short, the LED light strip can be arbitrarily cut or welded at the tangent of each group of scissors.

Leave a comment

Please note, comments must be approved before they are published